Sku : RP300

High Performance Door Rapid Protect™ 300 MP (High Speed Door)

Flexible High Performance Door, opening in vertical direction for use as a machine protection door.

  • Side frames - Made of aluminum with integrated safety switches, all fittings galvanized. Front of side frame lifts of for generous access to safety limit switches and fixtures.
  • Door curtain - Made of RollTex® Plus – color blue (similar RAL 5002), orange (similar RAL 2009), grey (similar RAL 7001).
  • Opening / closing speed - max 2.3/1.3 m/s (depending on size)
  • Wind protection - Through wind tabs on the door curtain.
  • Wind resistance - Class 1 (EN 12424).
  • Bottom profile - anodized aluminum
  • Drive unit - Hollow shaft gear motor, rotable in steps of 45°
  • Protection - IP 55
  • Control system - Frequency converter control system MCCVectorControl , based on Vector control and including boost function at start-up. Can be upgraded with a graphic display and foil keypad for easy guided operation. Easy access to all important information for operation and service
  • Control voltage - 24 V DC
  • Supply voltage - 3L(N)/380/400/415/440/480V; 50/60 Hz.Transformer necessary for 220/230/500V
  • Safety devices - Electrical safety contact edge, only available with MCC control unit. | No door line photocell | Cable chain integrated in side frame for evaluation of closing edge monitoring. | Drop down protection integrated in gear box. | Safety switches: Magnetic switch with evaluation unit for performance level e, acc. to EN ISO 13849-1, and SIL3, acc. to EN 62061, integrated in side frame.
  • Manual activation - By means of a crank
  • Size max - (DW x DH) 4000 x 3500 mm


  • Cover - Top roll cover: made of anodized aluminum | Motor cover: steel sheet, powder coated (similar RAL 9006)
  • Alternative control unit - Contactor control ACS 50, electronic control system with mini contactors including main switch and open-stopclose switch, control voltage 24 V DC (open/close), max. 1.0 / 1,0 m/s | Supply voltage: 3L(N)PE/230/380/400/415V; 50Hz, transformer for 440/480/500V necessary
  • Safeguarding the main closing edge - Self-monitoring electrical safety edge, additional door line photocell in the side frames, and opening / closing speed: max. 2.3/1.3 m/s with MCC control unit
  • Miscellaneous - Graphic display for MCC Vector Control unit |Bottom plates in the side frames   | Braces for floor assembly | Chain drive | X-level extensions of the side frames from the lower closing edge to the floor | Extended flexible seal | Actuator | Additional safety devices

Delivery - Installation incl. wiring

Enquire Now